Printed in China
31-31573 04-16 GE
ADVERTENCIA:
• Retire todos los conductores de corriente del electrodoméstico
de disyuntor o de la caja del fusible antes de comenzar con la
instalación. Si no cumple con esto, se podrá producir el riesgo
de descargas eléctricas.
• Para reducir el riesgo de descarga eléctrica, incendio o lesiones
a personas, el instalador debe asegurarse de que el lavaplatos
esté completamente cerrado en el momento de la instalación.
• La conexión inadecuada del conductor de conexión a tierra
del equipamiento puede provocar un riesgo de descarga
HOpFWULFD&RQVXOWHDXQHOHFWULFLVWDFDOL¿FDGRRUHSUHVHQWDQWH
de servicio técnico si tiene dudas sobre la correcta conexión
a tierra del aparato. Si el cableado doméstico no cuenta con
un cable de 2 hilos con conexión a tierra, un instalador debe
realizar una conexión a tierra. Cuando el cableado doméstico
es de aluminio, asegúrese de usar un compuesto antioxidante
y conectores de aluminio a cobre aprobados por UL.
• Para reducir el riesgo de descarga eléctrica, incendio o lesiones
a personas, el instalador deberá realizar un control para
asegurar que los cables no estén pellizcados ni dañados, que
HOFDEOHDGRGHOKRJDUHVWpFRQHFWDGRDOD¿FKDGHODFDMDGH
empalmes a través de un amortiguador de refuerzo, y que
todas las conexiones eléctricas realizadas en el momento de la
instalación (tuercas para cables) estén dentro de la tapa de la
caja de empalmes.
Installation Instructions
Built-In Dishwasher
If you have questions, call 800.GE.CARES (800.432.2737) or visit our Website at:
GEAppliances.com. In Canada, please call 800.561.3344 or visit www.geappliances.ca
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
FOR YOUR SAFETY
Read and observe all WARNINGS and CAUTIONS shown
throughout these instructions. While performing installations
described in this booklet, gloves, safety glasses or goggles
should be worn.
IMPORTANT –
Observe all governing codes and
ordinances.
• Note to Installer – Be sure to leave these instructions for the
consumer’s and local inspector’s use.
• Note to Consumer – Keep these instructions with your
Owner’s Manual for future reference.
• Skill Level – Installation of this dishwasher requires
basic mechanical, electrical and plumbing skills. Proper
installation is the responsibility of the installer. Product
failure due to improper installation is not covered under
the GE Appliance Warranty. See warranty information.
• Completion Time – 1 to 3 Hours. New installations require
more time than replacement installations.
IMPORTANT –
The dishwasher MUST be installed
to allow for future removal from the enclosure if service is
required.
Care should be exercised when the appliance is installed or
removed, to reduce the likelihood of damage to the power
supply cord.
If you received a damaged dishwasher, you should
immediately contact your dealer or builder.
Your dishwasher is a water heating appliance.
Optional Accessories – See the Owner’s Manual for available
custom panel kits.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING:
• Remove all power leading to the appliance from the circuit
breaker or fuse box before beginning installation. Failure
to do so can result in a risk of electrical shock.
•
7RUHGXFHWKHULVNRIHOHFWULFVKRFN¿UHRULQMXU\WR
persons, the installer must ensure that the dishwasher is
completely enclosed at the time of installation.
• The improper connection of the equipment grounding
conductor can result in a risk of electric shock. Check
ZLWKDTXDOL¿HGHOHFWULFLDQRUVHUYLFHUHSUHVHQWDWLYHLI\RX
are in doubt that the appliance is properly grounded. If
house wiring is not 2-wire with ground, a ground must be
provided by the installer. When house wiring is aluminum,
be sure to use UL Listed anti-oxidant compound and
aluminum-to-copper connectors.
•
7RUHGXFHWKHULVNRIHOHFWULFVKRFN¿UHRULQMXU\WR
persons, the installer should check to ensure that wires
are not pinched or damaged, the house wiring is attached
to the junction box bracket through a strain relief, and all
electrical connections made at the time of install (wire
nuts) are contained inside of the junction box cover.
