Installation Instructions
STEP 13 – CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8”, 3/4” or 1”
diameter connections on the air gap, waste tee or
disposer. Cut on the marked line as required for your
installation.
Cutting Lines
1"
3/4"
5/8"
IMPORTANT: Do not cut corruga
ted
portion of hose
Cutting Lines
IMPORTANT:
Do not cut corrugated
por tion of hose
• If a longer drain hose is required, add up to 42” of length
for a total of 10 ft. to the factory installed hose.
Use 5/8” or 7/8” inside diameter hose and a coupler to
connect the two hose ends. Secure the connection with
hose clamps.
Hose Clamp
Coupler
Coupler
Hose Clamp
Hose Clamp
• Secure the drain hose to the air gap, waste tee or disposer
with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer using
either previously determined method.
Waste Tee Installation
Disposer Installation
Method 2 - High drain loop with waste tee or disposer
Disposer Installation
Fasten to underside
of countertop
32"
Min.
18"
Min.
Fasten to underside
of countertop
18"
Min.
Waste Tee Installation
Method 1 - Air gap with waste tee or disposer
IMPORTANT -
When connecting drain line to
disposer, check to be sure that
drain plug has been removed.
DISHWASHER WILL NOT DRAIN
IF PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching
dishwasher drain hose to the disposer.
Remove
Drain
Plug
10
