– 18 –
Tub Seal
The dishwasher tub seal prevents water leakage.
The seal is fi tted in a seal channel that lines the rim
of the dishwasher tub.
To remove the tub seal:
Open the dishwasher door.
Grasp one end of the dishwasher tub seal and
peel it away from the seal channel.
1.
2.
Open the dishwasher door approximately 30
degrees.
Lift the bottom hinge arm up from the bottom
hinge, far enough to expose the hook.
11.
12.
Position hinge arm assembly to hang freely as
shown.
13.
Repeat steps 8 through 13 on the left side of the
door panel.
Remove the remaining three 8-mm nuts and
Phillips-head screws that hold the door panel to
the hinge assembly.
14.
15.
Reverse the above procedure to install.
Note:
When installing the tub seal, make sure it is
seated properly in the seal channel. Run your fi nger
over the seal to make sure it is smooth and even for
a proper seal. A correctly installed gasket will have
both ends of the gasket equidistant from the bottom
of the tub.
3.
Bottom Hinge
Hinge Arm
Hinge Arm
Assembly
Tub Seal
Seal Channel