– 13 –
Remove the 6 Philliips-head screws from the
control module.
Release the 2 top tabs and remove the control
module from the bottom 3 retainers.
4.
5.
Tabs
Retainers
Door Latch and Release Assembly
The door latch is permanently mounted to the top
of the dishwasher and is not replaceable. When
the door is in the closed position, the door latch
has dropped into place in front of the door switch
housing assembly and has pressed the switch
plunger down. This action holds the door fi rmly
against the seal, and the normally open contacts of
the door switches are closed.
The door release assembly is located on the inside
of the control panel. When the release handle is
pressed upward, it raises the door latch to clear the
front of the door switch housing assembly, releasing
the door.
To remove the door release assembly it will be
necessary to access the control panel. (See
Control
Panel
steps 1 through 3.) The door release is held to
the control panel with 2 Phillips-head screws.
Caution:
The door latch assembly may come apart.
Use care to assure the latch spring is not lost during
removal, handling, or installation.
To reassemble and reinstall the door latch
assembly:
Slide the latch spring onto the latch-block hinge
pin and hook the spring into the hole in the latch
block.
1.
Latch Spring
Latch Block
Hinge Pin
Hole
(
Continued next page
)
Note:
Wiring harness on the control assembly does
not disconnect. Control assembly must be replaced
as a unit.
Remove the control circuit board, control
module, and control module cover.
6.