16
49-90583-1
Installation Instructions
ROUGH-IN DIMENSIONS
DO NOT Install the Washer:
1.
In an area exposed to dripping water or outside
weather conditions. The ambient temperature should
never be below 60°F (15.6°C) for proper washer
operation.
2.
In an area where it will come in contact with curtains
or drapes.
3.
On carpet. The floor
MUST
be a hard surface with
DPD[LPXPVORSHRIƎSHUIRRWFPSHU
cm). To make sure the washer does not vibrate or
move, you may have to reinforce the floor.
NOTE:
,IIORRULVLQSRRUFRQGLWLRQXVHƎ
impregnated plywood sheet solidly attached to existing
floor covering.
IMPORTANT:
Minimum Installation Clearances
•
:KHQLQVWDOOHGLQDOFRYH6LGHV5HDU7RS ƎFP
•
:KHQLQVWDOOHGLQFORVHW6LGHV5HDU7RS ƎFP
)URQW ƎFP
• Consideration must be given to provide adequate
clearance for installation and service.
• Closet doors must be louvered or otherwise ventilated
and have at least 60 square inches (387.1 cm
2
) of
open area. If the closet contains both a washer and a
dryer, doors must contain a minimum of 120 square
inches (774.2 cm
2
) of open area.
LOCATION OF YOUR WASHER
NOTE:
With pedestal, 52.6”
Stacked, 84”
FRONT
27.0”
(68.6 cm)
39.8”
(101.09 cm)
SIDE
39.8”
(101.09 cm)
1700(5)/1600/1300/450/430/400 Series
models:
33.6” (85.3 cm)
1200/1100 Series models:
32.1” (81.3 cm)
MOBILE HOME INSTALLATION
Installation must conform to Standard for Mobile Homes,
ANSI A119.1 and National Mobile Home Construction
and Safety Standards Act of 1974 (PL93-383).
