P/N 1069686 • REV 1.0 • ISS 10MAR10
5 of 11
• DO NOT connect multiple outputs together.
• Make sure that the mains Voltage input is set to the proper local voltage.
Application Drawing
Figure 1: VPD Combiner Receiver Application diagram
Camera End Installation
Video:
Connect the baseband Video signal output of the camera to the BNC of
the GE single combiner receiver.
Data:
Connect the Data UTP pigtail (Black/White) of the GE single combiner
receiver to the data connector of the camera. There is no data connection on
GEC-VCR.
Power:
Connect the power UTP pigtail (Black/Red) of the GE single combiner
receiver to the power connector of the camera. Leave this power cable
unconnected for PTZ dome cameras.
Cat-5 Cable:
Connect the RJ-45 connector attached to the camera end of Cat-5
cable to the RJ-45 Jack of the GE single combiner receiver. Make sure that the
pin-out of the RJ-45 connector matches the pin-out of the GE single combiner
receiver.
