3.
Using pliers, squeeze the ears of the spring clamp
and position the clamp so the clamp ears align with
and contact the tabs on the drain hose. This as-
sures proper location of the clamp to prevent leaks.
INSTALLATION
Washer Connections
1. Run some water from the hot and cold faucets to
flush the water lines and remove particles that might
clog up the water valve screens.
2. Remove the inlet hoses and rubber washers from
the plastic bag located in the drum of the washer
and install the rubber washers in each end of the
inlet hoses.
3. Carefully connect the inlet hose marked "HOT" to the outside "H" outlet
of the water valve. Tighten by hand, then tighten another 2/3 turn with
pliers. Carefully connect the other inlet hose to the inside "C" outlet of
the water valve. Tighten by hand, then tighten another 2/3 turn with
pliers.
Do not crossthread or over-tighten these connections.
4.
Connect the inlet hose ends to the HOT and COLD water faucets tightly
by hand, then tighten another 2/3 turn with pliers. Turn the water on
and check for leaks.
NOTE:
Use only new hoses.
TIGHTEN
LOCK NUTS
TIGHTEN
LOCK NUTS
Leveling the Washer
Excessive noise and vibration can be prevented by properly leveling the
washer and tightening the leveling leg lock nuts.
1. For free standing installation and with the washer in it’s final position,
place a level on top of the washer. Adjust the leveling legs so the
washer is level front-to-rear and side-to-side, and stable corner-to-
corner. Press down on alternate corners and sides and feel for the
slightest movement. Adjust the appropriate leg so the washer is SOLID
on the floor on ALL four legs. Keep the leveling leg extension at a
minimum for best performance of the washer.
Once the unit is level and
stable in it’s final position,turn
the leveling leg lock nuts
against the base of the
washer and tighten with a
wrench.
2. For pedestal installations, remove the locknuts from each of the
washer legs. Reinstall each leg threading all the way into the base
(turn each leg tight to the base) before mounting on the pedestal.
See additional installation instructions included with the pedestal.
3. For undercounter installations the locknuts may need to be removed
before installing. Before installing, verify there is enough clearance for
the washer to be installed with the locknuts included. If space is not
available, remove the locknuts
from the leveling legs and
reinstall each leg by threading
all the way until tight in the
base. Remove the front
service panel and reinstall the
locknuts on top of the front
(2) leveling legs inside the
washer and tighten against
the leveling leg bushings once
the unit is in it’s final position.
