10
49-1000598 Rev. 0
ROLLERS AND LEVELING LEGS
Leveling legs
near each front corner of the
refrigerator are adjustable. They firmly position the
refrigerator and prevent it from moving when the
doors are opened. Leveling legs should be set so the
front of the refrigerator is raised just enough that the
doors close easily when opened about halfway.
Turn the leveling legs
clockwise to raise
the
refrigerator,
counterclockwise to lower it
.
CLEARANCES
Allow the following clearances for ease of
installation, proper air circulation and plumbing and
electrical conn ections.
6LGHV ´PP
7RS
´PP
%DFN
´PP
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT –
Save these instructions for
local inspector’s use.
•
IMPORTANT –
Observe all governing codes
and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer –
.HHSWKHVHLQVWUXFWLRQV
for future reference.
•
Skill level
±,QVWDOODWLRQRIWKLVDSSOLDQFHUHTXLUHV
basic mechanical skills.
•
Completion time
± 5HIULJHUDWRU,QVWDOODWLRQ
15 minutes
5HYHUVLQJWKH'RRU6ZLQJ
15
minutes
•
Proper installation is the responsibility of the
installer.
•
Product failure due to improper installation is not
covered under the Warranty.
REFRIGERATOR LOCATION
•
'RQRWLQVWDOOWKHUHIULJHUDWRUZKHUHWKH
WHPSHUDWXUHZLOOJREHORZ)&EHFDXVH
it will not run often enough to maintain proper
temperatures.
•
'RQRWLQVWDOOWKHUHIULJHUDWRUZKHUHWKH
WHPSHUDWXUHZLOOJRDERYH)&EHFDXVH
it will not perform properly.
•
'RQRWLQVWDOOWKHUHIULJHUDWRULQDORFDWLRQH[SRVHG
to water (rain, etc.) or direct sunlight.
,QVWDOOLWRQDIORRUVWURQJHQRXJKWRVXSSRUWLWIXOO\
loaded.
If you have questions, call 1.800.GE.CARES or
visit our Website at:
GEAppliances.com.
,Q&DQDGDFDOO
or
Visit our Website at:
geappliances.ca
INST
ALLA
TION INSTRUCTIONS
High
Leveling Leg
Lo
Installation
Instructions
GBE17HYRFS
REVERSE DOOR SWING
The door swing on this refrigerator can be reversed
IURPULJKWWROHIW)RUGHWDLOLQVWDOODWLRQSOHDVH
download the Owner’s Manual from website and follow
the instruction in the manual.
