31
www.GEAppliances.com
Wire cover holder.
Oven Shelves
Clean the shelves with an abrasive cleanser
or scouring pad. After cleaning, rinse the
shelves with clean water and dry with a
clean cloth.
If the shelves ever become hard to slide,
wipe the shelf edges or oven shelf supports
with vegetable oil.
NOTE:
Take the shelves out of the oven before you
begin the self-clean cycle or they may discolor.
Oven Light Replacement
CAUTION:
Before replacing your
oven light bulb, disconnect the electrical power to
the range at the main fuse or circuit breaker panel.
Be sure to let the light cover and bulb cool
completely.
The oven light bulb is covered with a
removable glass cover that is held in place
with a bail-shaped wire. Remove the oven
door, if desired, to reach cover easily.
To remove:
Hold a hand under the cover so
it doesn’t fall when released. With
fingers of the same hand, firmly
push back the wire cover holder.
Lift off the cover.
Do not remove any screws to remove
the cover.
Do not touch hot bulb with a wet
cloth. Replace bulb with a 40-watt
household appliance bulb.
To replace cover:
Place it into the groove of the light
receptacle. Pull the wire forward to the
center of the cover until it snaps into
place. When in place, the wire holds
the cover firmly. Be certain the wire
is in the depression in the center of
the cover.
Connect electrical power to the range.
Consumer Service
Operating Instructions
Safety Instructions
Installation Instructions
Tr
oubleshooting T
ips
