Operating Instructions
Safety Instructions
Installation Instructions
Tr
oubleshooting T
ips
Consumer Support
46
Before you call for service…
Problem
Possible Causes
What To Do
Excessive smoking
Excessive soil.
•
Touch the
CLEAR/OFF
pad. Open the windows to rid
the room of smoke. Wait until the light on the
SELF
CLEAN
pad goes off. Wipe up the excess soil and reset
the clean cycle.
Oven door will not open
Oven too hot.
•
Allow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after
Oven controls not properly set.
•
See the
Using the self-cleaning oven
section.
a clean cycle
Oven was heavily soiled.
•
Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or for
a longer period of time.
Oven door will not
Oven is too hot.
•
Allow the oven to cool below locking temperature.
unlock (on models
Do not lock the door with the door latch except when
with a door latch)
using the self-clean feature.
“Door” appears in the
Self-cleaning cycle has been
•
Move the latch handle all the way to the right.
display (on models
selected but the latch handle
with a door latch)
was not moved all the way
to the right.
Latch handle was moved to the
•
Move the latch handle to the right only when setting
right but a program other than
the self-cleaning cycle.
self-cleaning was selected.
“F—and a number or
On models with a door latch,
•
The latch may have been moved, even if only slightly,
letter” flash in the display
if a function error code appears
from the locked position. Make sure the latch is moved
during the self-cleaning cycle,
to the right as far as it will go.
check the oven door latch.
You have a function error code.
•
Touch the
CLEAR/OFF
pad. Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats.
•
Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Display goes blank
A fuse in your home may be
•
Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is turned off so that it
•
See the
Using the clock and timer
section.
does not show in the display.
Display flashes
Power failure.
•
Reset the clock.
Unable to get the
Oven control pads were
•
The
BAKE
and
BROIL HI/LO
pads must be touched at
display to show “SF”
not touched properly.
the same time and held for 3 seconds.
Troubleshooting Tips
