GE CTT14CYT, Инструкция по использованию, уходу и установке

Страница: 12 / 40

REVERSING THE DOOR SWING
(continued)
REVERSE CABINET HARDWARE.
1. Transfer the bottom hinge to the left.
a. Remove the base grille if your refrigerator has
one. Grasp it at the bottom and pull it straight out.
b. Using a Torxdriver, remove the hinge bracket
(and shim glued to it), and plastic washer from
the bottom right side of the cabinet.
c. Reinstall the hinge bracket (and shim glued
to it) and plastic washer on the bottom left side of
the cabinet.
2. Transfer the top hinge to the left.
Reinstall the top hinge (and shim glued to it) on
the left front corner of the cabinet, but do not
tighten the screws at this time.
Some hinges have four holes. Which holes you
use for installing the hinge depends on which
side you install the hinge.
The outer edge of the hinge should be parallel to
the edge of the case for correct installation.
3
REVERSE THE DOOR HANDLES.
(on some models)
1. Transfer the fresh food door handle
to the right.
To remove the handle…
a. Remove the handle plug using a tape-tipped
putty knife under the edge, and remove the
screw underneath.
b. Remove two screws holding the handle to the
top of the door.
c. Remove the handle.
After removing the handle…
a. Remove the screws from the right edge of
the door top and insert them into the handle
screw holes on the opposite side.
b. With tape-tipped
putty knife or thin-
blade screwdriver,
pry out the plug
button from the
hinge hole on the
left side of the door
and insert it into the
hole on the opposite
side that was
vacated by removal
of the top hinge.
c. Pull the plug
button from the
front of the door
and transfer it to
the opposite side.
4
Plastic
Washer
Hinge
Pin
Bottom
Hinge
Bracket
LEFT SIDE
PLUG
BUTTON
PLUG BUTTON
SCREWS FOR
HANDLE HOLES
RIGHT SIDE
TOP
BOTTOM
12
Installing the hinge
on the left
Installing the hinge
on the right