210572217 Rev. B 3-08
NOTE:
The fan’s receptacle wires might need to be
pulled outside compartment for connection. Only pull
the loose wires outside of compartment. Additional
wires will be present.
4. Carefully tuck wires back inside wire compartment
and replace wire compartment cover securing with
the screw that was removed earlier.
SECTION 6
Completing the Installation
1. If the fan’s blower assembly was removed during
the wiring process, reinstall the blower by reversing
the directions in
Step 1b in
Section 5
Wiring.
2. Plug the fan’s quick connect motor cord into the
receptacle. This cord will only fit one way into the
receptacle
(Figure 9)
.
3. Install the included 26 watt fluorescent lamp into the
lamp holder by lining up the pins on the lamp base
to the socket of the lamp holder and pressing towards
the lamp holder until the lamp snaps into place and
is firmly seated in the lamp holder. Install a 4 watt
maximum type C7 (candelabra base) night light (not
included) into the side lamp holder
(Figure 10)
.
4. Install the grill by squeezing the two ends of the springs
together and installing them up into the slots on the
fan’s housing. Push the grill up into position
(Figure 11)
.
5. Restore power and test your installation.
SECTION 7
Use and Care
CAUTION:
MAKE SURE POWER IS SWITCHED
OFF AT SERVICE PANEL BEFORE SERVICING THE UNIT.
1.
Cleaning the Grill:
Remove grill and use a mild
detergent, such as dishwashing liquid, and dry with
a soft cloth. NEVER USE ANY ABRASIVE PADS OR
SCOURING POWDERS. Completely dry grill before
reinstalling. Refer to instructions in
Section 6
Finishing the Installation, to reinstall grill.
2.
Cleaning the Fan Assembly:
Wipe all parts with a
dry cloth or gently vacuum the fan. NEVER IMMERSE
ELECTRICAL PARTS IN WATER.
CAUTION:
ALLOW BULB TO COOL BEFORE
REPLACING.
4 of 8
Figure 11
www.geelectrical.com
Figure 8
Hot
(Black)
White
Supply from
house
Ground
Hot
(Purple)
Hot (Yellow)
Figure 9
Figure 10
Pin
Socket
Lamp
Lamp Holder
Night Light
