210572123 Rev. D 1-08
1a. From where you have access to inside the fan’s
junction box, connect the one white wire from the
house to both the white wire from the fan’s light
receptacle and the white wire from the fan’s exhaust
receptacle. Connect the first black wire from the
wall switch to the red wire from the fan’s light
receptacle. Connect the second black wire from the
house to the fan’s exhaust receptacle. Connect the
ground wire from the house to the green wire from
the fan’s grounding screw
(Figure 8)
. Use approved
methods for all connections.
2.
Wiring Fan/Light together:
Run wiring from an
approved wall switch carrying the appropriate rating.
One neutral (white), one ground (green or bare
copper), and one hot (black lead connected to the
switch). Secure the electrical wires to the housing
with an approved electrical connector. Make sure
you leave enough wiring in the box to make the
connection to the fan’s receptacle.
2a. From where you have access to inside the fan’s
junction box, connect the one white wire from the
house to both the white wire from the fan’s light
receptacle and the white wire from the fan’s exhaust
receptacle. Connect the black wire from the wall
switch to both the red wire from the fan’s light
receptacle and the black wire from the fan’s exhaust
receptacle. Connect the ground wire from the house
to the green wire from the fan’s grounding screw
(
Figure 9)
. Use approved methods for all connections.
SECTION 6
Completing the Installation
1. Reinstall the fan’s venturi by holding it at approximately
a 45 degree angle, hook the two tabs on the venturi
into the slots on the housing and secure in place by
tightening the venturi screw. Rotate the blower wheel
by hand to ensure it spins freely. Now plug the fan
motor into the receptacle
(Figure 10)
.
2. Install the grill/lens/light reflector, by first removing
the lens from the grill (there are two tabs on either
side that hold the lens in place). Then remove the
acorn nut and the lock washer which are installed
on the reflector mounting bolt in the fan housing.
Adjust the height of the reflector mounting bolt so
that the grill will be tight up against the finished
ceiling and less than 1/4" of the reflector mounting
bolt protrudes through the reflector. Secure the
reflector bolt’s position by tightening the factory
installed nut against the motor clip (
Figure 11)
.
CAUTION:
FAILURE TO SECURE THE REFLECTOR
BOLT MAY RESULT IN A RATTLING OR HUMMING NOISE.
3. After the reflector bolt is secure, raise the grill/reflector
up into position, and plug the reflector into the
appropriate receptacle. Secure the assembly to the
reflector bolt using the acorn nut and lock washer.
Install a 100 watt maximum, type A19 medium base
incandescent bulb and reinstall the lens into the grill
(
Figure 12)
.
4 of 8
Figure 9
Ground
Hot (Red)
Supply
from
house
White
Figure 8
Ground
Hot (Red)
Supply
from
house
White
Figure 10
Figure 11
Tabs
Lens
Grill
Reflector
Motor Clip
Mounting Bolt
Nut
Acron Nut
Lock Washer
www.geelectrical.com
Hot (Black)
Hot (Black)
