Auxiliary controls on your Zoneline.
GEAppliances.com
Auxiliary Controls—Aux Set Button
The auxiliary set controls are located behind
the room cabinet, below the control panel.
Remove the room cabinet. See the
to Remove
the Room Cabinet
section.
The owner is responsible for ensuring the auxiliary
controls are set to the desired function. There are 9
different modes that can be set using the auxiliary
set button. To change modes, press
AUX SET
(“AU”
appears on the display). Press the mode button on
the control pad until the first digit in the display
shows the number corresponding to the mode you
are choosing and the correct HEAT/COOL LED is lit.
Press the up or down arrow (shown in the second
digit of the display) to make the mode setting
selection where applicable. Press the
AUX SET
button to confirm the selection.
Sa
fe
ty
In
str
uc
tio
ns
O
pe
ra
tin
g I
ns
tru
cti
on
s
Ca
re
a
nd
C
lea
nin
g
Tro
ub
les
ho
ot
in
g T
ip
s
Co
ns
um
er
S
up
po
rt
Smart Fan—Cooling/Heating
The default setting for Mode 1 is as follows:
Cooling: Continuous (ON)
Heating: Cycle (OFF)
Press
MODE
until a 1 appears in the first digit of the
display for
Smart Fan
cool mode. The
COOL
LED
light on the main control will be on. To change to
heat mode, press
MODE
again. The
HEAT
LED light
on the main control will be lit. Press the down arrow
to set the indoor fan to cycle on/off when the unit is
heating or cooling " ." Press the up arrow to set
the indoor fan to run continuously " ." This is
shown in the second digit of the display. Press
AUX
SET
to confirm your selection and exit
AUX SET
mode, or press
MODE
to continue setting other
functions.
8
Auxiliary Set Button
Access Cover
Cooling – Cycle*
Heating – Cycle*
Cooling – Continuous
Heating – Continuous
MODE 1
HIGH
COOL
LOW
FAN
AUTO
HEAT
HIGH
COOL
LOW
FAN
AUTO
HEAT
HIGH
COOL
LOW
FAN
AUTO
HEAT
HIGH
COOL
LOW
FAN
AUTO
HEAT
Load Shedding (Central Desk Control)
The default setting for Mode 2 is OFF.
This feature is active only if the unit is connected to
a CDC and the CDC has control. Press
MODE
until a
2 appears in the first digit of the display for
Load
Shedding
mode. Press the down arrow for OFF "
" or the up arrow for ON " ." This is shown in the
second digit of the display. When this mode is on,
only the indoor fan can be turned ON or OFF with
the unit controls. When this mode is off, all
operation is disabled except Heat/Freeze Sentinel
(Mode 3). Press
AUX SET
to confirm your selection
and exit
AUX SET
mode, or press
MODE
to continue
setting other functions.
Load
Shedding
OFF
Load
Shedding
ON
MODE 2
5
*Note: In cyclic cooling mode, the indoor fan will activate occasionally to
verify airtemperature in the room. In cyclic heating mode, the fan will
continue to operate for 90seconds after the heating function has stopped in
order to increase unit efficiency.