GE Advantium 120 SCA1000, Техническое обслуживание руководство

Страница: 29 / 74

– 27 –
Serviceability with Oven Installed
WARNING: Before proceeding, remove all power
to the oven by turning off the appropriate circuit
breaker or unplugging the power cord.
WARNING: When reassembling the product,
remember to reattach all ground wires and put
screws in their correct locations.
Note: This unit contains various types and sizes
of screws. Be certain to keep screws sorted. Be
certain to use the correct screws for each panel
and component when reassembling.
The following components can be accessed from
the front of the oven with the unit installed:
• Grille
• Oven door
• Cooktop light
• Oven light
• Vent cover
• Control panel
• Door interlock switches
• Main PCB
• Sub PCB
• Fuses
• Low voltage transformers
• High voltage transformer
• Magnetron
• Damper assembly
• Capacitor and diode
• Magnetron TCO
• Hood TCO
• Cavity TCO
• Turntable motor
• Lower heater
Grille
1. Remove 2 screws from the top of the oven.
GEA00995
Screws Screws Screws
Grille Grille Grille
2. Open the door, pull the top of the grille out
while pressing up on the bottom to release the
lower locking tabs, and remove the grille.
Door Removal
WARNING: A microwave leakage test must be
performed any time a door is removed, replaced,
disassembled, or adjusted for any reason. The
maximum leakage is 4 MW/cm
2 (refer to
Microwave Leakage Test on page 41).
1. Open the door and remove any trays or grilles
from the oven.
2. Remove the grille (see procedure).
3. Lift the door up until the hinge pins clear the
hinge holes.
4. Slide the door off the hinges and remove.