GE 60000 Series, Руководство оператора

Страница: 20 / 124

20
Changing Engine Oil
KEEP OUT OF REACH OF CHILDREN. DON’T POLLUTE.
CONSERVE RESOURCES. RETURN USED OIL TO
COLLECTION CENTERS.
Change oil while the engine is still warm from running.
1. Turn the generator off.
2. Remove control board fuse from control board.
3. Place oil drain hose (B) into an approved container.
4. Open valve (A) located on bottom of oil pan.
C
B
Shown here is the oil drain hose (B) and the oil filter location
(C) for the 60kW generator:
To make the task of adding oil more convenient, we
recommend use of a funnel attached to a length of tubing long
enough to reach from the Coolant Fill door to the oil fill opening
on the engine valve cover.
5. When oil has drained, replace brass fitting on hose.
6. Add the required amount of oil to bring the level up to,
but not over the “FULL” mark on the dipstick. Reinstall
the oil filler cap to valve rocker arm cover and wipe
any excess oil clean.
7. Reinstall control board fuse in control board.
8. Turn the generator on and place in AUTO mode.
CAUTION Avoid prolonged or repeated skin contact with used
motor oil.
• Used motor oil has been shown to cause skin cancer in certain
laboratory animals.
• Thoroughly wash exposed areas with soap and water.
A
Engine V‑Belts
The engine installed in this equipment uses drive belt(s) that
drive the water pump and alternator. The drive belt(s) are an
integral part of the cooling and charging system and should be
inspected according to the maintenance schedule.
When inspecting the belts, check for:
• Cracks
• Chunking of the belt
• Splits
• Material hanging loose from the belt
• Glazing, hardening
If any of these conditions exist, the belt should be replaced.
C
B
B
A
NOT
for
REPRODUCTION