GE 60-806, Инструкция пользователя, Страница: 21 / 40

Security Pro 500
14
4. Press
‚
+
4
+
ƒ
to exit the programming menus.
Adjusting the Touchpad Beeps
The frequency or pitch of chime and trouble beeps from each fixed display touchpad can be
adjusted individually to a more desirable or distinct tone.
Chime and trouble beep tones sound using the default frequency during, or within 15 seconds of,
any button activity at that specific touchpad.
¾
To change status tone pitch:
1. Press and hold the
‚
and
0
until you hear a steady tone, then release the buttons.
2. Press and hold
1
to lower the pitch or press and hold
2
to raise the pitch.
3. Release the button when the desired pitch is heard.
After about 10 seconds of no touchpad activity, the steady tone stops sounding.
Adjusting the Touchpad Display Brightness
You may want to change the brightness of a touchpad display based on its location in a building
or room. For example, dim the touchpad display in a bedroom or enhance a display near a win-
dow.
Changing the touchpad display affects only the touchpad currently being used.
¾
To change touchpad display brightness:
1. Enter the programming menus by pressing
9
+ System Master Code .
2. Press
2
+
2
.
3. Select a brightness level:
Š
0
+
ƒ
Off
Š
1
+
ƒ
Low
Š
2
+
ƒ
Medium
Š
3
+
ƒ
High
4. Press
‚
+
4
+
ƒ
to exit the programming menus.
After dimming the display, pressing any button momentarily returns the display to full bright-
ness. After 15 seconds without touchpad activity, the display returns to the set dimmed level. If
an alarm occurs while the display is dimmed, it automatically returns to the full brightness level
and stays that way until you disarm your system.
Notification by
Pager
Your system can notify up to three different pager phone numbers to report system events. The
installer can program any pager to receive pages for one or more of the following groups:
• High Level Reports, which includes the following reports:
– Sensor alarms – Bus failures
– Sensor Tamper – No activity alarm
– Sensor Restores – Fire panic
– Phone test – Police panic
– Receiver failure – Auxiliary panic
– Receiver jam – Duress alarm
– Touchpad tamper
• Low Level Reports, which includes the following reports:
– Bypass sensors – AC power fail
– Sensor Low battery – CPU low battery
– Sensor Supervisory – Auto phone test
– Sensor Trouble – CPU back in service
– Phone test – Phone Failure
– Touchpad supervisory – Event buffer full
– Touchpad low battery
– Force armed(reports when a user bypasses sensors while arming system)