GE 33712, Инструкция по эксплуатации

Страница: 8 / 29

8
Programming Your Remote
tv
Note: The red light will either be a small light at the
top of the remote or the power on/off button.
3. Press and release the device button on the
remote for the type of device you wish to
control,
(for example
TV, strm, b-ray, cbl,
dvd, aud).
The red light will blink once and
remain on.
4. With the remote pointed at the device,
press and release the
POWER button
on the remote. The remote will send 10
different codes to the device. The red light
will blink once for each code and remain
on after sending the 10 codes.
Did the device turn off?
• If
YES, go to Step 5.
• If
NO, repeat Step 4 to test the next
10 codes.
5. Manually turn the device back on.
6. With the remote pointed at the device,
press and release the
VOL + button. The
remote will re-send the first code of the 10
codes from Step 4. The red light will blink
once and remain on.
Auto Code Search
The Auto Code Search is a process where you can
search through all the codes stored in the remote to find
a code for your device. It is recommended that you read
through all the steps below to familiarize yourself with
the
Auto Code Search before starting the process.
1. Manually turn on the device you wish
to control.
Note: The Auto Code Search process cannot be used
for devices without power on/off capability. Use the
Direct Code Entry method in these cases.
2. Press and hold down the
SETUP button on
the remote until the red light on the remote
control turns on. Release the
SETUP button.
The red light will remain on.