8
ANTI-BACTERIAL
This option may only be used with
COTTONS
or
NORMAL/MIXED LOAD
cycles . This option reduces
(on some models) certain types of bacteria by 99 .9%, including: Staphylococcus aureus, Pseu-
domonas aeruginosa and Klebsiella pneumoniae* . The anti-bacterial process occurs when high heat
is used during a portion of this drying cycle .
NOTE:
Do not use this cycle on delicate fabrics .
* The Anti-Bacterial Cycle is Certified by NSF International (formerly National Sanitation Foundation) to
NSF Protocol P154 Sanitization Performance of Residential Clothes Dryers.
HIGH
For regular to heavy cottons .
MEDIUM
For synthetics, blends and items labeled permanent press .
LOW
For delicates, synthetics and items labeled Tumble Dry Low .
EXTRA LOW
For lingerie and special-care fabrics .
4
Sensor Dry
“Level”
The sensor continuously monitors the amount of moisture in the load . When the moisture in your clothes reaches your
selected dry level, the dryer will stop .
Note:
Sensor dry
“LEVEL”
only works for
COTTONS, NORMAL/MIXED LOAD, ACTIVE WEAR, DELICATES, and SPEED DRY
.
5
Dry
“
Temp”
You can change the temperature of your dry cycle .
6
START
Press to start a dry cycle . If the dryer is running, press it once and it will pause the dryer .
Press it again to resume the dry cycle .
My Cycle
Set up your favorite combination of settings and save them here for one touch recall .
These custom settings can be set while a cycle is in progress .
To store a MY CYCLE combination of settings:
1 . Select your drying cycle .
2 . Change
DRY “
TEMP”
, and
SENSOR DRY
“LEVEL”
settings to fit your needs .
3 . Select any drying
OPTIONS
you want .
4 . Press and hold the
M
Y
C
YCLE
pad for three seconds to store your selection . A beep will sound and the pad will light
up .
To recall your stored MY CYCLE combination:
Press the
MY CYCLE
button before drying a load .
To change your stored MY CYCLE combination
:
Follow steps 1–4 in
“To store a MY CYCLE combination of settings”
.
8
“CLEAN LINT FILTER” (message)
(This message represents only a reminder and does
not
always appear when filter needs cleaning . The filter should be
cleaned after every drying cycle is complete .)
This message will disappear after the
START
button is pressed . Even though you may have already cleaned the filter
(before or after the
POWER
button has been pressed), the
“CLEAN LINT FILTER”
message will still be displayed until the
START
button is activated .
7
