14
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT –
Save these
instructions for local inspector’s use.
•
IMPORTANT –
Observe all
governing codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer –
Keep these instructions
for future reference.
•
Skill level
– Installation of this appliance requires
basic mechanical skills.
•
Completion time
– Refrigerator Installation
15 minutes.
•
Proper installation is the responsibility of the
installer.
•
Product failure due to improper installation is not
covered under the Warranty.
•
Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run often
enough to maintain proper temperatures.
•
Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not perform
properly.
•
Install it on a floor strong enough to support it fully
loaded.
REFRIGERATOR LOCATION
If you have questions, call 1.800.GE.CARES
or
visit our Website at:
www.GEAppliances.com
Installation
Refrigerator
Instructions
Models 18 and 19
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
•
Sides 1/8
″ (3
mm)
•
Top 1
″ (25
mm)
•
Back 1
″ (25
mm)
If the refrigerator is to be installed next to a wall on the
hinge side, allow 5/16
″
(8 mm) door clearance.
CLEARANCES
If the refrigerator has an icemaker, it will have to be
connected to a cold water line. A GE water supply kit
(containing tubing, shutoff valve, fittings and
instructions) is available at extra cost from your dealer
or by visiting our Website at www.GEAppliances.com
or Parts and Accessories, 800.626.2002.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS)
The rollers have 3 purposes:
•
Rollers adjust so the door closes easily when opened
about 45°.
•
Rollers adjust so the refrigerator is firmly positioned on
the floor and does not wobble.
•
Rollers allow you to move the refrigerator away from the
wall for cleaning.
NOTE:
When rollers are properly adjusted, the top
of the refrigerator will not be level but will have a slight
backward tilt.
For models with a base grille,
the grille must be removed
to access the roller adjusting screws.
To remove the base grille:
Grasp it about 6
″
from each
end and pull its bottom edge
toward you.
To replace the base grille:
Insert the tops of the metal
clips into the oval vents,
making sure one of the
plastic tabs on the back of
the grille goes into each of
the oval vents. Then push the
bottom of the grille forward
until it snaps into place.
To adjust the rollers,
turn
the two front roller adjusting
screws
clockwise to raise
the
front of the refrigerator,
counterclockwise to lower
it.
ROLLERS
(ON SOME MODELS)