GE Security Simon XT, Руководство по установке, Страница: 49 / 84

Chapter 4
Programming
39
Sensors
These instructions tell how to add (learn) sensors, touchpads, and other system devices into panel memory. The
panel recognizes a sensor when you press a sensor program button, press and release a tamper switch, press a
sensor test button, or put a sensor into alarm.
Table 14 describes the programming method for each device.
Note: If you are installing a sensor on a gun case, jewelry box, or a similar case, and the sensor is active in level one, you must
subdisarm to avoid putting the panel into alarm when the sensor and the magnet are separated.
When learning sensors, the panel uses an ascending number sequence starting with 1. You can override this by
entering the desired sensor number using the number keys.
Call wait code Off The call waiting code is dialed by the panel before a phone number to disable call
waiting. Verify that the end-user has call waiting with his phone service provider before
changing this option from its default.
CAUTION: Changing this option from its default without call waiting will prohibit
the panel from calling the central station.
The call waiting code is programmed the same way as a phone number.
Table 14. Device programming
Device To program
Door/window sensor Press the button on the top of the sensor (cover removed) or trip the tamper.
Motion sensor Press the button on the back of the sensor (mounting plate removed) or trip the tamper.
Smoke detector Trip the tamper, press the test button, remove the detector from its base, or put the
smoke detector in alarm.
Hardwired sensor Separate the sensor from its magnet.
CO alarm Plug in the module wait 5 to 7 seconds press and hold the test button for nine beeps
Freeze and water sensor Trip the tamper or press and hold the button on the top of the sensor (cover removed)
until the control panel confirms programming. If you do not hold the button down long
enough, the system will report the sensor as open.
Personal help button Press the help button until the light blinks.
Remote handheld touchpad Press the emergency buttons.
Keyfob Press the lock and unlock buttons at the same time.
ELM keyfob Do the following:
1. Press the unlock button twice and hold it the third time. The light button flashes
three times.
2. Press the unlock button once and hold it the second time. The light button
flashes twice.
3. Press and hold the unlock button. The light button flashes once. Hold the button
until the flashing stops.
Table 13. Phone options (continued)
Function Default Description