Arming your system in the “STAY mode”
STAY is utilized when the user is inside the premise and wants protection around the perimeter. The steps to arm in
the STAY Mode are as follows:
Step 1
Close all protected doors and windows.
•
The
System Ready
message will be displayed when all protected zones and sensors are secure.
NOTE: If any zones are bypassed, a sensor in that zone can be violated without affecting
the ready light.
•
The security system will not arm if the
System Not Ready
message
is displayed. It can be force
armed if the entire
System Not Ready
message is flashing. Refer to the following section,
"Making Your System Ready to Arm".
•
If the
Service Required
” message is alternated displayed, you
may not have AC power. Restore power if possible. If not,
contact the installing company.
Step 2
Enter your 4 or 6 digit user code. (Optional, if programmed.)
•
If “Auto Bypass” is enabled, all interior zones will be bypassed if you do not leave through a
designated entry/exit door. If Auto Bypass is enabled, omit Step 3.
•
When “Auto Instant” is enabled, if you do not leave through a designated entry/exit door, the
display will read “
Instant
”, indicating that the entry/exit doors no longer have an entry delay.
If “Auto Instant” is enabled, omit Step 4.
Step 3
Press the
[STAY]
key.
•
The
[
STAY
]
key will illuminate indicating that all interior zones are bypassed. (All interior
devices will bypass automatically, giving the user freedom of movement within the interior
area.)
•
The
[
BYPASS
]
key will illuminate if any zone(s) are bypassed. If any zone(s) have been
bypassed previously by the user, the light(s) corresponding to the bypassed zone(s) will
illuminate, alerting the user that a zone(s) may be unprotected and can be faulted without an
alarm.
Step 4
To toggle between the STAY and NIGHT mode, double press the key corresponding to the mode
you desire.
Step 5
To upgrade from the STAY
or NIGHT mode to the AWAY mode, double press
[
AWAY
].
Note
: Once the AWAY mode is activated, the system must be disarmed to revert to the STAY
or
NIGHT mode.
System Ready
Type Code to Arm
System Armed
Instant
•
The LCD display will read “Instant” meaning the entry/exit
doors do
NOT
have an entry delay.
Using the Quick Arm (optional)
The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user to arm the security system in the
AWAY
/ STAY
/ NIGHT modes by pressing the corresponding
[
AWAY
],
[
STAY
],
[
NIGHT
] key twice. This
feature is used for ARMING ONLY, and will not disarm the security system. This is ideal for a maid or baby sitter, etc.
NX-1248E User manual
Page 9
16/04/05
