Unbypassing
Step 1
Press the
[BYPASS]
key.
Step 2
When the LCD prompts for a code (optional, if programmed), enter your user code.
Step 3
The bypass light flashes.
Step 4
Enter the zone number (each time 2 digits) of the zone(s) that must be unbypassed.
(Example: to bypass zones 4 en 5, press [0][4][0][5].)
Step 5
Press the
[BYPASS]
key again.
Step 6
The
bypass light
will stop flashing.
NOTE: All zones will automatically be unbypassed each time the system is disarmed.
ADDING AND
CHANGING USER CODES
Your system must be
Disarmed
to add/change user codes.
Step 1
Press [
r
]-[
5
]
Step 2
Enter a “Master Arm/Disarm Code”.
NOTE: For partitioned systems, someone changing the code of another person must
have access to all or more partitions than the user being changed.
Step 3
Enter the 2 digit (applies to NX4/6/8) or 3 digit (applies to NX8E) “user number” (always enter
2 digit such as [
0
] - [
3
] for user 3, or [
1
] - [
0
] - [
0
] for user 100).
The LCD keypad will display the current code for this user. Stars (
r
) represent blanks.
Note
: To delete a user code, press four times (for a 4-digit code), or six times (for a 6-digit
code) the (
r
) key.
Step 4
Enter the new four (4) or six (6) digit “user code”. If you are changing the current code, you may
use the up and down scroll keys to select the digit to change and enter the correct number. If it
rejects the code because of duplication or such, the sounder will beep 3 times.
Step 5
If another “user code” needs to be programmed, return to Step 3.
Step 6
Press the [
#
] key while the
ready light
is flashing to exit the User Code Programming Mode.
NX-1248E User manual
Page 12
16/04/05
