GE MDS MDS SD4 Series, Руководство для стартапов

Страница: 5 / 20

05-4669A01, Rev. B MDS SD4 Startup Guide
3
INSTALLATION
There are three main requirements for installing the transceiver:
• Adequate and stable primary power
• An efficient and properly installed antenna system
• Correct data connections between the transceiver and the data
device.
Figure 3 shows a typical remote station arrangement. This is followed
by step-by-step procedures for installing the transceiver and making
front panel connections.
Table 1. SD4 Available Accessories
Accessory Description Part Number
DC Power Plug,
2-pin, polarized Mates with power connector on
radio. Screw terminals provided for
wires, threaded locking screws to
prevent accidental disconnect. 73-1194A39
Retrofit Kit, Digital Contains all items needed to replace
an existing MDS x710A/C/M digital
transceiver. 98-6190ACC1
Retrofit Kit, Analog Contains all items needed to replace
an existing MDS x710A/C/M
transceiver used in the analog
mode. 98-6190ACC2
Reference Manual Contains technical information,
system design data, and a complete
list of software commands. 05-4670A01