- 50 -
December 22
nd
, 2022
GDC SR-1000 STANDALONE INTEGRATED MEDIA BLOCK
™
INSTALLATION MANUAL
16. SR-1000 INPUT AND OUTPUT
4
Connection to D-Box
AES output 13
on the SR-1000 carries the Motion
Data signal used by D-Box (assuming DCPs follow the
16 channels ISDCF recommended channel order).
The
AES pair 13/14
is available on the
RJ45 Connector
labeled
A-bot
on the IMB and can be connected to the
D-Box system. Appropriate cable and connectors should
be chosen keeping in mind the connector used on the
D-Box system.
5
Connecting a Microphone
*
A Microphone can be connected to the
MIC. IN
on the
front panel of the AIB-2000 using a
Male XLR
Connector
.
If the microphone requires Phantom power, then press
the
+48V
button.
6
Connecting a Non-Sync source
*
A Non-sync source can be connected to the
NON-SYNC
IN
on the front panel of the AIB-2000 using Male XLR
connectors or to the
NonSync IN
on the back panel
using Male stereo
RCA Connectors
.
NON-SYNC
front/back button switches NonSync input
between front
XLR
and rear
RCA Connectors
.
7
Connecting an HDMI source
An HDMI source can be connected to the
HDMI IN
on
the faceplate of the SR-1000, using an HDMI cable.
8
Connecting a Booth Monitor
*
A Booth monitor can be connected to the
LCR mon
output on the back panel of the AIB-2000 using an
RCA
Connector
.
Please note that the LCR mon output provides a L+C+R
summation of the AES3 outputs from the SR-1000.
Table 4
* Refer to the ‘
AIB-
2000 Manual’
for more details.
IMPORTANT
: Please check and set the levels of the analog input sources to the AIB-
2000 appropriately, to avoid any damage to the auditorium speakers.
