23
Control Knob
Fig. 3
Relative positions of markings on
side of upper knob.
Position - OFF
Position - IGNITION
Position - LOW
Position - HIGH
Fig. 3b
Fig. 3a
Owner Guide
2.0 Introduction & Operation
2.3
Operating units fitted with the
Comfortstat control.
1. The appliance is controlled by two knobs
which are positioned at the lower right on the
front of case (Fig. 3).
The upper knob has four positions.
2.
To light the appliance
(Fig 3a): At the OFF
( ) position push the upper control knob as far
as possible and still pushing in
slowly
turn
anti-clockwise to the ignition position ( ) to light
the burner. Turning the control knob slowly
allows gas to enter the burner ready for ignition.
Keep the knob pushed in for 10 seconds and the
burner should remain alight. If not, repeat the
sequence.
NOTE:
Under extreme wind conditions more
than one attempt to light the appliance may
be required.
3. Once lit, the control knob can be altered to the
High or Low heat settings.
4. When first lit after installation some smells are
likely to be emitted. These will quickly clear away
with use.
NOTE:
If the appliance goes out at any time
wait 3 minutes and repeat the procedure.
When changing from one setting to another
the knob should always be pushed in slightly.
5.
To adjust the thermostat setting
(Fig 3b)
:
The lower control knob alters the temperature
setting, the knob has seven positions.
6.
To turn the appliance off:
Push the knob in
slightly and turn to the OFF ( ) position.
Position
Position
Position
Position
OFF
IGNITION
LOW
HIGH
Markings on lower knob.
