DU-FLP-0008-53 Rev C 03/28/16 GCX Corp Page 6 of 6
Removing and Replacing Storage Bin
1. To remove, flex both sides of the Bin upward to disengage it from the mounting bracket.
2. To replace, place the Bin on the mounting bracket and flex both sides of the Bin upward while applying downward
pressure to reengage with the bracket
– the Bin will snap into place when properly installed.
3. Snap opposite side on.
Cable Management
Keyboard and Mouse cables may be routed through slots located at the backside of the keyboard tray
Routine Maintenance
Periodically inspect all fasteners associated with the mounting assembly. Tighten or Adjust as necessary for optimal
operation and safety.
Cleaning the Mounting Assembly
1. The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in the hospital
environment (e.g. diluted bleach, ammonia, or alcohol solutions).
2. The surface finish will be permanently damaged by strong chemicals and solvents such as acetone or
trichloroethylene.
3. Steel wool or other abrasive material should never be used.
4. Damaged caused by the use of unapproved substances or processes will not be warranted. We recommend testing
of any cleaning solution on a small area of the mounting assembly that is not visible to verify compatibility.
5. Never submerge or allow liquids to enter the mounting assembly. Wipe any cleaning agents off the mounting
assembly immediately using a water-dampened cloth. Dry the assembly thoroughly after cleaning.
CAUTION:
GCX makes no claims regarding the efficacy of the listed chemicals or processes as a means for controlling
infection. Consult your
hospital’s infection control officer or epidemiologist. To clean or sterilize mounted devices or
accessory equipment, refer to the specific instructions delivered with those products.
2
1
1