DU-FLP-0008-53 Rev C 03/28/16 GCX Corp Page 4 of 6
Adjusting the Display height
1. To change primary height adjustment tension, remove
protective cap to expose Lock Nut. Use a
½” (13mm)
socket wrench to tighten or loosen the Lock Nut to
adjust fit in L-Bracket. Place the protective cap on the
Lock Nut once adjustment is completed.
2. To change secondary height adjustment, hold Display,
loosen Height Adjustment Knob, move Display to
desired vertical position and tighten Height Adjustment
Knob.
Adjusting Display Tilt Tension
1. To adjust tilt tension on the Display Mount, equally
loosen or tighten the two (2) Tension Adjustment Screws
with
5/32” Hex Wrench until desired tension is achieved.
Adjusting Folding Tension on the Keyboard Bracket
Tilt Tension Screws (2)
If the Folding Keyboard Bracket becomes difficult to fold or will not maintain the folded (upward) position, adjust folding
tension as described below:
1. Pry Plastic bolt covers off each end of the Tension Bolt. Replace bolt covers after adjustment. Using a 1/2" [13mm]
wrench on each end of the bolt, tighten or loosen bolt until desired tension is achieved.
1
Folding Tension Bolt
Plastic Bolt Covers (2)
Folding Tension Bolt