Page 11
Once the print is removed, inspect it to see how it printed using the current settings. You can record
what happened with each print and over time it will become intuitive.
If the print has any stringing or globs stuck to the side you can carefully use a blade to remove the
plastic or in some cases it just flakes off.
Note: A heat source, such as a lighter, works great to heat the plastic to
fix any problem areas and to smooth very sharp edges. Use caution
when using the lighter because smoke particulate may stain the model.
Remember you just want the heat from the flame not the flame itself to
touch the model. This method will also remove any slight stringing.
