GBC Talon 44 CE, Руководство по установке и эксплуатации

Страница: 35 / 42

Operations Manual
Page 35
T
ALON
44/64
CE
©2004 General Binding Corporation
Maintenance
Caring for the
GBC Talon 44/64 Laminator
GBC offers Cleaning kits as well as Extended Maintenance
Agreements.
Contact your local GBC Service Representative or your
dealer/distributor for additional information.
The only maintenance required by the operator is to peri-
odically clean the heat rollers and schedule semi annual
maintenance checks.
The following procedure will help keep the heat rollers
free of adhesive that has been deposited along the edge
of the laminating film. Proper alignment of the rolls of film
reduces the amount of “squeeze out”.
WARNING: Do not attempt to laminate adhesives
marked “Flammable”.
• Do not laminate glitter and/ or metallic items. Damage
to the rollers may result.
WARNING: Do not apply any cleaning fluids or
solvents to the rollers. Some solvents and fluids
could ignite on heated rollers.
• Never clean rollers with sharp or pointed objects.
• Hardened adhesive deposits on the rollers can cause
damage to the rollers. Rotate the rollers at the lowest
speed setting on the control panel.
CAUTION: THE FOLLOWING PROCEDURE IS
PERFORMED WHILE THE LAMINATOR IS HOT.
USE EXTREME CAUTION.
1. Remove the film from the laminator following the
procedure outlined in steps 1 through 6 of the section
entitled TO UNWEB THE LAMINATOR.
2. Preheat the laminator until the “READY” indicator
appears.
3. Remove the safety shield and tilt the feed table.
4. Rub the top and bottom heat rollers with a 3M™
Scotch-Brite™ pad. DO NOT USE METAL SCOURING
PADS!
5. Use the footswitch to rotate the lower heat/ pull roller
to an unclean portion. The upper heat/ pull rollers are
free spinning. Continue this process until the entire
surface of both rollers are clean.
6. Refer to the beginning of the section entitled OPER-
ATING INSTRUCTIONS to web your laminator.