GBC Talon 44 CE, Руководство по установке и эксплуатации

Страница: 24 / 42

Operations Manual
Page 24
©2004 General Binding Corporation
T
ALON
44/64
CE
Loading Top Thermal Film
This procedure describes how to load the upper roll of film
onto the laminator. Figure 24 uses poly-in film and the upper
rear unwind/ rewind position for illustration purpose.
1. Turn the Power ON/OFF (I/O) to ON (I). Set top heat
temperature for the film type you are using.
2. Ensure no brake tension is applied to the film shaft.
3. Remove the safety shield and pivot the feed table
down.
4. Pull the top roll of film down under the idler bar and
allow to drape over the top heat roller (Figure 24).
5. Reference one of the loading bottom material proce-
dures.
Loading Top PSA Film
This procedure describes how to load the upper roll of film
onto the laminator. Figure 25 uses PSA film and the upper
rear unwind/ rewind position for illustration purpose.
1. Turn the Power ON/OFF (I/O) to ON (I). If the laminator
is already hot, turn POWER ON/OFF (I/O) to the OFF
(O) position and allow the unit to cool. Once cool, turn
the laminator back on.
2. Ensure no brake tension is applied to the film shaft.
3. Remove the safety shield and pivot the feed table
down.
4. Set the roll of film in the rear unwind/ rewind position
and the rewind tube in the front unwind/ rewind posi-
tion.
5. Pull the top roll of film down under the idler bar and up
the upper front rewind tube.
6. Place one piece of masking tape in the center of the
film and secure to the rewind tube.
7. Make two full wraps around the rewind tube, then care-
fully score the laminate without cutting the release
liner.
8. Pull the laminate down allowing it to drape over the
upper main roller.
9. Reference one of the loading bottom material proce-
dures.
Fig 24
Fig 25