Falcon 60+ (-1)
Falcon 60+ (-1)
Operations Manual
© 2003 General Binding Corporation
Page 25
Heat
The “READY” indicator may extinguish if the speed
is set too fast for the material being laminated.
Either lower the speed setting or press STOP and
wait until the “READY” indicator illuminates.
Operation of the laminator for more than thirty
minutes at a time may necessitate a lower speed
setting. It is recommended that, during periods of
long runs, the items being laminated are alternated
between thick and thin. Do not combine thick and
thin items at the same time, as this will result in a
poor edge seal around the thinner material. If you
are unsure that the laminator is set at the proper
speed for the item to be laminated, run a test piece
(scrap) of the same or similar material through the
laminator.
This procedure is recommended
because rotating the heat roller prior to lamination
will more evenly distribute the heat. Make speed
adjustments if necessary.
Output
1. “D” waves in the image (Figure 45 A).
– Check paper tension.
– Paper may be damp or not dry.
2. “D” waves in the laminate (Figure 45 B).
– Check main roller pressure.
– Check pull roller pressure.
3. Straight waves in output (Figure 46 A).
– Check operational settings for
m a t e r i a l s
being used.
– Check clutch tension.
4. Indent waves in output after pull rollers
(Figure 46 B).
– Insufficient cooling time.
– Output was handled prior to cooling.
– Use cooling feature if not on.
– Machine was stopped on print.
5. Angled waves in the output
(Figure 47 A & B).
– Main air supply setting.
– Check main roller pressure.
– Check pull roller pressure.
– Check for even paper tension. (Figure 49 A only)
Fig 45
Fig 46
Fig 47
Содержание Falcon 60+ (-1)
Страница 1: ......
