GBC 930-028, Руководство по эксплуатации и техническому обслуживанию

Страница: 23 / 48

F-60+ Operation and Maintenance Manual Operation
© GBC Pro-Tech 1999 April 3-5
+HDWLQJ
Use the following instructions when heating one or
both of the laminating rolls. The procedure is the same
for the top and bottom heaters.
1. Set the heater switch to ON.
2. Adjust the temperature controller for the desired
operating temperature using the temperature con-
troller push buttons.
3. When heating the rolls, keep the top roll down and
turning at a moderate speed to prevent uneven
heating.
4. It will take approximately 30 minutes for the lami-
nating roll(s) to reach operating temperature. When
the preset operating temperature has been reached,
the machine is ready to use.
3XOO 5ROO &OXWFK $GMXVWPHQW
The F-60+ Laminator has an adjustable clutch for the
pull rolls on the machine, allowing you to adjust the
amount that the film is tensioned as it leaves the main
rolls and is cooled. The clutch adjustment is made by
using the knob on the drive side of the machine.
Pull roll clutch tension adjustment:
Turning the knob clockwise increases tension.
Turning the knob counterclockwise decreases tension.
CAUTION
3DSHU 7LSV
Always feed prints perpendicular to the laminating
rolls.
1. Lock core support to middle of the shaft. Lock two
core chucks on shaft ends, located to support mate-
rial a few inches from ends of the roll.
☞
Note
Paper unwind may require two evenly spaced core sup-
ports if wide rolls of prints (paper) are used.
2. Place the roll on the unwind shaft.
3. Carefully close the unwind shaft, holding the roll
away from the hinge.
4. When the shaft is in the saddle, push in the locking
pin.
5. Center the roll of material.
6. Web and tension film per process control chart and
diagram.
When the machine is not in use, the pull rolls
must be raised to prevent damaging the rolls.