GBC 930-028, Руководство по эксплуатации и техническому обслуживанию

Страница: 20 / 48

Operation F-60+ Operation and Maintenance Manual
3-2 © GBC Pro-Tech 1999 April
2SHUDWRU &RQWUROV
The operator controls for the F-60+ Laminator are
located on the front and rear of the unit, to the right of
the operator position. The names and functions of these
controls are as follows:
)URQW &RQWURO 3DQHO
Figure 3-4: Front Control Panel
1. ROLL PRESSURE DISPLAY - Displays the per-
centage of force pushing the main laminating roll
down.
2. RUN/STOP/EYE RESET – Turns the drive sys-
tem on or off and resets the photoelectric eyes
when in automatic forward mode. The photoelec-
tric eyes do not function in reverse mode.
3. MOTION CONTROL FORWARD/REVERSE -
Controls the direction of the drive system, forward,
reverse, or stop.
4. SPEED ADJUSTMENT – Adjusts the speed of
the machine from zero to the maximum as the con-
trol is turned clockwise. (Turtle is slow, rabbit is
fast.)
5. UPPER ROLL HEATER CONTROLLER –
Provides a readout of the temperature of the upper
roll and the set-point for the desired temperature.
☞
NOTE
The bottom roll heater controller must be turned on
before the top roll heater controller will energize the
top heater.
6. UPPER ROLL HEAT ON/OFF – Turns the
heater controller for the upper main roll on or off.
7. LOWER ROLL HEATER CONTROLLER–
Provides a readout of the temperature of the lower
roll and the set-point for the desired temperature.
8. LOWER ROLL HEAT ON/OFF – Turns the
heater controller for the lower main roll on or off.
9. COOLING FAN ON/OFF – Turns the cooling fan
on or off.
10. POWER ON/OFF INDICATOR – Indicates
when the main power is being applied to the
machine.
)RRWVZLWFK 2SHUDWLRQ
The footswitch can be used for feeding materials
through the main rolls (forward mode). Material speed
is controlled by the Control Panel Speed Adjustment
knob, resulting in constant speed operation when the
footswitch is pressed. The footswitch can also be used
for feeding materials through the pull rolls (reverse
mode). Material speed is controlled by the footswitch,
which operates much like the accelerator on an auto-
mobile.
CAUTION
Figure 3-5: Using the Footswitch
Power On/Off
Indicator
Motion Control
FORWARD/
REVERSE
Speed
Adjustment
1
3
4
5
6
7
10
RUN/STOP/
EYE RESET
2
CAL 3200
2
100
90
80
70
60
50
40
30
20
10
Upper Roll Heat
ON/OFF
Cooling Fan ON/OFF
Upper Roll Heater
Controller
1
2
3
4
5 6
7
8
9
10
CAL 3200
Lower Roll Heater
Controller
Roll
Pressure
Display
8
Lower Roll Heat
ON/OFF
9
When the footswitch is used the photoelectric eye
guarding the main rolls is turned off. Release the
footswitch to stop the machine rolls.
WA RN
IN G
AC
HT UN
G
MI
SE EN G
AR DE
WA
RN IN
G
AC
HT
UN G
MI SE EN
G AR
DE
PRO-TECH
F-6
0+
™
Press Footswitch
(variable speed)
Feed
Material
Into Nip
CAL 320 0
2
100
90
80
70
60
50
40
30
20
10
1 2
3 4 5 6
7 8
9
10
CAL 320 0
Remove
Guard