7-3
Operating Instructions
62FM L
AMINATOR
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
Unsatisfactory adhesion of
laminate.
Speed setting too fast for type of
material being laminated.
Lower speed setting by pressing
Slow
button to slower speed
Insufficient heat.
Wait for
READY
indicator to appear in
the control panel display.
Laminate improperly loaded.
Adhesive side of film must be facing
away from the heat rollers.
Bottom roll of film not threaded behind
the idle bar.
Heat rollers require cleaning.
Clean heat rollers per procedure in
section
Maintaining the 62FM Laminator.
Laminated item unsuitable for adhesion.
Item may be dirty or may have
nonporous surface that is extremely
difficult to laminate.
Waves in my output
See sub section
Output
.
Under section titled
Lamination Guide.
Nips may be out of calibration.
Place a service call for calibration check.
Содержание 62FM
