GBC 62FM, Руководство по установке и эксплуатации

Страница: 24 / 41

3
Operating Instructions
62FM L
AMINATOR
Fig. 6-3. Poly-in and Poly-out Configurations.
L
OADING
F
ILM
Lift up on the round end, left side, of the
unwind/rewind shaft.
Pull the hex end, right side, of the shaft out and
away from the laminator.
Slide the roll of film onto the film shaft ensuring
adhesive side is out.
Replace the shaft with the hex end in first then
the round end.
Center the roll of film.
L
OADING
T
HERMAL
F
ILM
T
OP
T
HERMAL
F
ILM
This procedure describes how to load the upper roll
of film onto the laminator. Fig. 6-4 shows poly-in
film and the upper rear unwind/rewind position for
illustration purpose.
Fig. 6-4. Loading Top Thermal Film.
Turn the
Power I/O (On/Off)
to ON
(I).
Set top heat temperature for the film type you
are using.
Ensure no brake tension is applied to the film
shaft.
Remove the safety shield and pivot the feed
table down.
1.
2.
3.
4.
5.
1.
2.
3.
4.
Poly-in
Poly-out
Adhesive surface
Polyester surface
Polyester surface
Adhesive surface