Gazer H714, Руководство пользователя

Страница: 10 / 56

Usage
Note: Before adjusting the «Car battery protect» setting consult
with your car service station.
When the ACC power is off, the MVR can operate in two modes that can
be selected in the «Parking Mode» menu.
1. MVR operation with the «Parking Mode» off.
In this mode, once the ACC power is turned off, the MVR continues
recording for one hour (set as default) but its recording speed is
reduced to 10 frames per second to save space on your memory
card. If the G-sensor detects an impact, this recording will be
automatically protected to prevent accidental overwriting. The
G-sensor can be adjusted in the «Shock Sensitivity» menu where 10
is maximum value and 2 - minimum. Power consumption in this mode
is 90mA.
2. MVR operation with the «Parking Mode» on.
In this mode, once the ACC power is turned off, the MVR stops
recording the video and switches to the standby mode. If the
G-sensor detects an impact, the system will record a 60-90 sec
video at the speed of 30 frames per second. The resulting video file
will protect the file from overwriting. If the «Shock Sensitivity» is
disabled and the engine is off the G-sensor default sensitivity is 5.
Power consumption in this mode is 80mA.
You can use the MVR for security recordings when the car is parked.
When the ACC powers off the MVR will continue recording for the
period set in the «Auto-off time». Only after that will it shut down.
If «Never» setting is selected, the MVR continues recording and
shuts down only when the battery voltage drops below the value set
in the «Car battery protect» menu. This prevents the car battery
from complete discharge.
MVR installation
Warning! Wipe the surface of the windshield before installing. Make sure
the installation place is dry and clean. Do not install the mount on 3M
scotch tape at temperature below +5°C. Because of such low
temperature and the difference between the temperature inside the car
and outdoors, the 3M scotch will lose its adhesive properties and will not
be able to fix the mount properly.
Prior to installing, determine the exact
MVR position on the windshield. Mark the
installation place. Remember that once
the mount is installed on the car
windshield, you cannot change the
horizontal position of the device (side to
side), only vertical position (up and down)
can be changed afterwards.
Make sure that the device is installed
in a position from which hit can be
conveniently removed later. Fix the
mount so that other objects do not
prevent you from monitoring status
indicators, removing the memory card
or pressing any of the buttons.
By vertically turning the MVR frame point
the lens down at about 15°.
Remove the protective film from
3M tape.
Mount the device on the car windshield.
To remove the mount from the 3M
tape on the car windshield, take a
ruler or credit card and push it gently
between the mount and the
windshield.
1 2
3 4
5 6
ENG
10