![Gazelle PACER Скачать руководство пользователя страница 2](http://html1.mh-extra.com/html/gazelle/pacer/pacer_owners-manual_3818920002.webp)
c.
Slide the swing arms onto the axle
tube & align axle to properly fit
into frames. At the same time slip
the frame assemblies together at
the bottom of the unit.
d.
Place bolts, flat washers & spring
washers into each axle end, & bolts &
spring washers you removed in step b
into each bottom frame. Do not
completely tighten bolts (hand tighten).
Handlebar Assembly
h. To assemble the handlebars
you will need to remove the
bolts & washers from
handlebars. Slide left &
right bars into swing arms.
Line up holes & insert
washers & bolts. Tighten
with the wrench provided.
e.
Stand the unit up as shown by lifting up on the axle tube
while holding one side of the frame. Be sure the swing
cables hang straight down allowing the cables & swing
arms to move freely.
f.
Open your unit. (Make sure it is completely open.) Tighten
front & rear frame bolts at the bottom of the unit.
g.
Finally, tighten the screws on the axle tube ends. For best
results, use both wrenches simultaneously to tighten
these bolts securely.
Before tightening the axle tube, make sure the screw in the
center of the axle tube faces the top of the unit.
This will help for proper alignment of electronics.
Note: If you notice any gaps after tightening, or extra space
in the top crossbar, use enclosed spare “C” washers. Do not
put “C” washers between center sleeve & swing arms.
screw in axle tube
faces top of unit
axle tube
swing arm
d
d
c
g
f
f
f
g
e
lift from here
h
© 2022, 2017 Gazelle Home, LLC. Gazelle
®
is a registered trademark. All rights reserved.
No part of this document may be reproduced or utilized in any form, by any means electronic, mechanical or otherwise without the express written consent of the copyright holder.
GAZPACERASBLY1022