6
times are shortened, replace the battery. Charge the battery in time. Do not use up all the battery
power. This will cause permanent failure of the lithium battery.
2. When tools are not used for a long time, the battery will self-discharge. You should remove the
battery and
keep it fully charged every quarter.
3. Do not use wires to connect the poles of the battery, which may cause sparks, combustion or
even explosion. Do not use damaged batteries or chargers, which increase the risk of electric
shock.
4. Burning the battery is not allowed under any circumstances, or it will cause an explosion.
5. When the battery is charging, do not use any object to cover the charger, so that the charger can
not dissipate heat, easy to lead to fire.
6. Disconnect the charger when not in use. This will reduce the risk of injury to children and
untrained personnel.
7. Do not use the charger in wet conditions or be exposed to rain or snow, which increases the risk
of electrocution.
8. Do not disassemble the battery and charger without permission. If any fault occurs during use,
please refer to the professional or manufacturer for maintenance until the problem is solved.
4.2
Tool operation
4.2.1 Check whether the LED indicator is on. If the indicator is on for more than 5 seconds, the
battery is out of power and should be replaced with a fully charged battery.
4.2.2 Press the clamping pin and put into the corresponding dies.
4.2.3 Place the crimping material into the pliers and install the lock.
4.2.4 Press the start button to start crimping.
4.2.5 The crimping is completed after the die is completely closed or reaches the maximum
crimping force.
V.
Maintenance
5.1 The tool is precise, please use it correctly. Non-professionals do not disassemble it, we
will not be responsible for the damage caused by not following the operation instructions.
5.2 Keep tools dry. Water may corrode surface metal or electrical parts. If comes into contact
with water, remove the battery and dry completely before assembling.
5.3 Avoid violent temperature fluctuations. Otherwise, it will cause deformation of the
plastic shell, shorten the service life and damage the battery. Please do not use any chemical
