34
8.10 TOWING DEVICE
Front and rear towing devices consist of towing fork with pivot bolt locked
at below with cotter pin.
Before towing the vehicle remove the front licence plate to make access to
the towing fork. For towing the vehicle in heavy road conditions with small
turning radiuses and so on, it is recommended to remove the bumper to pre
vent its damage. In so doing it is necessary to undo 4 screws of bumper middle
part fastening and one nut (17 mm width across flat) at each side of bumper
sidewalls fastening.
9. Vehicle Maintenance
This section describes the works, which should be carried out regularly
within the intervals between the maintenance operations stated in the Service
Book.
9.1. CHECKING ENGINE OIL LEVEL
Check engine oil daily prior to engine starting. When doing so park the
vehicle on level ground. The oil level must be between "П" and "0" marks on
the oil dipstick (nearer to "П" mark). Bring it to the proper level if required.
Pour fresh engine oil via the filler neck covered with the cap.
9.2. CHECKING OIL LEVEL IN GEARBOX AND REAR AXLE
Check oil level on an unladen vehicle standing on level ground with the
units cold.
Oil level in the gearbox (Fig. 9.1) should be to the level of the filler hole
lower edge.
Fig. 9.1.
Checking Oil Level in Gearbox:
1 — drain hole plug
2 — filler hole plug
