Gaz Industrie BTwin BTH25, Технические инструкции

Страница: 8 / 28

- 8 -
Assembly the bend (E) on the tubes Make certain that the screw (A2) goes through the
elongated hole (A1) in the tube ensuring so that the moving burner bend come to a standstill !!
Assembly the burner block (F) on the tubes. Make certain that the screw (A2) goes through
the elongated hole (A1) in the tube ensuring so that the moving burner block will come to a
standstill !!
Attention : Take off the plastic protection of the reflectors (G).
Put the fixing brackets of the reflectors (H) in open position.
Place the reflector (G) with the rectangular nick at the Ubend side into the brackets grooves.
- Put the fixing brackets of the reflectors (H) in closed position by blocking the screw for
maintaining the reflectors in place.
Inclination 40mm ±10
The total gradient of the heater must be 40 mm ±10 in the direction of the Ubend
E
D
F
G
H
G
G
A1
A2