7.2.
Preparing the remote reflector for use
Caution! Do not touch the inside of the reflector during installation.
•
Switch off mains power.
•
Install the lamp in the remote reflector (see paragraph 9.1).
•
Hang the remote reflector by its two mounting points (9). The two mounting
points are spaced 347 mm / 13.66 inches apart.
7.3.
Connecting the remote reflector to a ballast
Warning! Ensure the cord is not coiled and does not touch any hot surfaces.
Warning! Make sure mains power is switched off.
•
Plug the lamp cord into the ballast (10).
•
Connect the ballast to mains.
•
Switch on mains power.
8.
Product use
Warning! Never use the remote reflector without a lamp or reflector!
9.
Inspection, maintenance and repair
Warning! Disconnect the product from mains before performing any
maintenance or repairs.
Warning! Do not disassemble the remote reflector, this will void the warranty.
Warning! Always allow for a cool down period of at least 30 minutes before
touching the lamp or reflector.
Caution! Do not clean the remote reflector with detergents, abrasives or other
agressive substances.
Caution! Do not touch the inside of the reflector during installation and do not
use water, abrasives or detergents to clean it. This will damage the reflective
surface.
Caution! Ensure the exterior of the remote reflector is dry after cleaning it.
•
Regularly check the remote reflector for dust or dirt buildup. Clean if necessary.
Contamination may couse overheating and decreased performance.
-
Clean the inside of the reflector only with a soft, dry cloth;
-
Clean the outside of the remote reflector using a dry or damp cloth.
•
Check the lamp monthly for discolorations or black markings. Always replace a
damaged lamp.
Note: Before initial use, the lamp could have black markings. This will disappear
when the lamp runs on full power. If not, replace the lamp.
•
Regularly check the wiring of the product to ensure it is undamaged.
347 mm / 13.66 inch
9.
10.
EU
US
1000W
1 m -
40 in
750W
0.75 m -
30 in
