10
Pro
line
Pro
line
9.2
Error or warning indications
Status LED message
Status luminaire
Description
Action / Solution
Too low voltage
Input voltage is too low
Check mains voltage
Too low voltage occured
in past
See above, reset
Too high voltage
Input voltage is too high
Check input voltage, check wiring
and connection, check neutral in
3 phase systems
Too high voltage occured
in past
See above, reset
Too high temperature
Electronics temperature is too
high (max. 115 °Celsius )
Disconnect from mains. Check
installation, clean ballast, check
environment temperature (max
35 °Celsius). Make sure the
luminaire is not heated by HPS
lamp light. Wait until the lamp is
cooled down, then reconnect to
the mains.
Too high temperature
occured in past
See above, reset
No signal from
controller
Luminaire is connected to the
mains and set to EXT but there is
no signal on the control input.
If a controller is connected,
search for loose connections,
defect contacts or short-circuits.
10
Inspection, maintenance and repair
6
Warning!
Disconnect the product from mains before performing any maintenance or repairs.
6
Warning!
Do not connect or disconnect the Wieland RST20i3 plug under load.
6
Warning!
Do not open or disassemble the luminaire, it contains no servicable parts inside. Opening the luminaire can
be dangerous and will void the warranty.
6
Warning!
Always allow for a cool down period of at least 30 minutes before touching the lamp or reflector.
1
Caution!
Do not clean the luminaire with detergents, abrasives or other agressive substances.
1
Caution!
Do not touch the inside of the reflector during installation and do not use water, abrasives or detergents to
clean it. This will damage the reflective surface.
2
Note:
Gavita recommends to measure the lamp and reflector for aging every year. Replace the lamp and/or reflector
when they are aged.
•
Regularly check the luminaire for dust or dirt buildup. Clean if necessary. Contamination may couse overheating and
decreased performance.
− Clean the inside of the reflector only with a soft, dry cloth;
− Clean the electronic ballast and the outside of the luminaire using a dry or damp cloth.
•
Check the lamp monthly for discolorations or black markings. Always replace a damaged lamp.
1
Note:
Before initial use, the lamp could have black markings. This will disappear when the lamp runs on full power. If
not, replace the lamp.
•
Regularly check the wiring of the product to ensure it is undamaged.
10.1
How to disconnect the Wieland RST20i3 plug
6
Warning!
Do not connect or disconnect the Wieland RST20i3 plug under
load.
1. Switch off mains power.
2. Press the pin on the Wieland RST20i3 male connection inwards and pull the
Wieland RST20i3 female connection from the luminaire (18).
B
B2
1
18
