38
Page P.16
Upper figure:
The figure shows the attachment options for a 6-cell rechargeable battery. The required triangular holders are glued to the
chassis with liquid instant glue in addition to the screw connections. The rechargeable batteries are attached with the
included hook-and-loop tapes.
Lower figure:
Cut out the cabin hood according to the drawing.
Important!
The right half of the hood has a lower adhesive groove that must be retained when cutting out.
Also do not cut right along the edge at the upper and rear openings, but leave an edge of approx. 2 mm. The remaining
angle of the material clearly increases stability of the hood.
First join the hood sides „dry“ and fasten the seams with a few strips of adhesive take on the outside. When the hood halves
match perfectly, bond them from the inside using liquid instant glue.
The position of the hood attachment rubbers is marked ex works. Pre-drill the holes and expand the bore to approx. 7 mm.
Then install the attachment rubbers and install the hood holder to the chassis. Use the two bores at the top chassis edge
right behind the rotor shaft.
The hood can be decorated with the included decals.
Page P.17
This page includes the optionally offered accessories and improvement parts.
Attention!
Please observe that the 6-digit numbers in the manufacturer’s manual are no Conrad order numbers!
For the current list of spare parts with the corresponding Conrad Electronic order numbers, see www.conrad.de in
the download area of the respective model helicopters.
