__
Copyright © 2008 Gator. All Rights Reserved.
42
5. Mount Adhesive Base to Dash
Position the adhesive base on the area of the dash you cleaned with the alcohol pad. Press
down with even pressure for 30-60 seconds to fully secure base to the dash.
* Skip to Step 7. Step 6 for Windshield Mounting only
6. Secure Suction Cup Base to Windshield
Install the included suction cup to the mount by pushing the threaded part through the
mount so the threads are on the top side of the mount base (hint: press the suction cup
threads firmly through the hole on the mount to make sure you can get enough
movement when tightening to create a good seal on the glass. If you have trouble
attaching to the glass after tightening up the nut you may not have the windshield suction
cup base seated far enough into the mount.)
Ensure nut is tightened down enough to form a tight seal between mount and windshield
glass. Ensure device can be viewed safely/properly in chosen location.
7. Secure Mount to Base
Place mount onto base thread. Secure mount to base by tightening nut. Ensure device can
be viewed safely/properly in chosen location.
8. Mount Device to Base Using Included Adapters
Included adapters are designed to fit a specific device only. Be sure to choose the correct
adapter for your specific device/model.
WARNING: Improper or incorrect adapter use may damage the mount or the device.
Attach the appropriate included adapter onto the back of your device (see images below
for reference). Slide the adapter into mount base slot and lock retainer tab as shown.
9. Mount Device Using Universal Adhesive Mount Tabs
To attach a device for which an adapter has not been included, use the supplied universal
adhesive mount tabs. Attach the adhesive mount tab to an appropriate location on the
back of your device. Slide the adapter into mount base adapter slot.
To Adjust/Tighten Mount Arm Joints
To further adjust mount arm pivot/tension, remove the nut from the mount base and use
the integrated hex nut tool to loosen/tighten mount arm pivot joints. After adjusting to
desired tension, re-tighten nut down to re-secure mount/ device to base.
