Gateway E-1600, Системное руководство

Страница: 50 / 108

42
Replacing and Adding System Components
7
Remove the two screws that secure the power supply to the back panel,
then slide the power supply slightly forward and remove it from the
chassis.
To install the new power supply:
1
Make sure that the new power supply matches the one you removed. The
specifications and power output connectors should be the same.
2
Make sure that the red voltage selector switch on the back of the new
power supply is set to the proper voltage for your area.
3 Place the new power supply in position in the chassis and about an inch
away from the back panel.
4
Slide the power supply back to engage the tab on the bottom of the
chassis with the slot in the bottom of the power supply.
5
Replace the two screws you removed earlier to secure the power supply
to the back panel.
6
If your computer includes an air duct, replace the air duct over the
processor and the power supply fan.
7 Reconnect the power cables to the system board and to all internal
devices.
8
Close the case by following the instructions on page 18.
9
Reconnect the peripherals, the modem cable, and the power cord, then
turn on the computer.
8506999.book Page 42 Friday, December 15, 2000 8:22 AM