Gates UNIPRESS 4, Руководство по эксплуатации

Страница: 20 / 54

20
GATES.COM
UNIPRESS 4 (UP4)
OPERATION MANUAL
4. OPERATION
4.1 START OF OPERATION
Activate the control of the machine with the 0-1 switch.
The pressing operation is started by actuating the button.
4.1.1 USE
The machine is assigned to its intended use only.
4.1.2 SAFETY PRECAUTIONS
Never remove or alter any safety facilities or signs attached to the machine!
This would pose a threat to life or physical condition!
Damaged signs or safety facilities shall be replaced instantly!
The machine must stand on a level, steady and slip-proof surface!
The machine owner is obliged to lay down the tasks of the persons responsible for the
correct operation of the machine!
Heed all the valid health, work and fire protection regulations when operating the
machine!
Before starting, the operating staff must check the machine, making sure that it is in
operational and functional order; eliminate all risks for persons or the machine!
If a dangerous situation for man or equipment arises, take the necessary steps to
prevent injury or damage immediately!
Heed all safety precaution and warning signs attached to the machine!
The personnel qualified for working with the machine shall study the operation manual
thoroughly prior to starting, especially the chapters on safety instructions. Once the
machine has started, it will be too late! This is most important for persons who don’t
usually work with the machine, e. g. setting-up or maintenance staff!
Handle machines in a technically faultless condition only; use according to
regulations, beware of danger, take no security risks and observe the OM! Any
interference relating to safety aspects should be eliminated immediately!
Special attention must be paid towards the risk of exceeding or falling below the
capacity marks indicated in chapter “Technical Data”! If the owner fails to prevent
misuse of the machine, he allows for a further potential source of danger to
operational safety!
Unauthorised alterations are prohibited!
Never open protective caps before pulling out the plug!