Gates GC16XD, Инструкция по безопасности и эксплуатации

Страница: 17 / 24

15
CALIBRATION
GC16XD MINI CRIMPER & PUMP SAFETY & OPERATION MANUAL
Insert 16-33 Dies Into Head
Unpack 33 Dies from Container insert each individual die
into shoe, 8 dies total
Adjust Dial Indicator Knob
Adjust dial indicator knob to number 0123. This number is
the factory calibration number for a 1” inch crimp.
This crimp machine has a dial indicator to visually show when the operator needs to stop hydraulic flow to the
head. It is advisable that you get use to the dial indicator before calibrating. This is usually done by crimping the
same specification assembly many times and note the difference in COD with each assembly. The calibration
process is trial and error, with the goal of being confident that you can repeatedly crimp to 1.000 +/- .003” using
the dial indicator.
Crimp 8G MegaCrimp
®
While holding the thread end of an 8G MegaCrimp
®
coupling,
insert coupling into crimper so that ferrule is 1/8” from front
edge of die shoe.