23
© 2011 Gates Corporation
EZ ALIGN is a registered trademark of Gates Corporation
Special precautions have been taken to assure proper
calibration, however calibration is not covered by this warranty.
Calibration maintenance is the responsibility of the user.
The foregoing states the entire liability of
GATES
CORPORATION
regarding the purchase and use of its
equipment.
GATES CORPORATION
will not be held responsible
for any consequential loss or damage of any kind.
This warranty is in lieu of all other warranties, except as set
forth above, including any implied warranty merchantability or
fitness for a particular purpose, are hereby disclaimed. This
warranty is in lieu of all other warranties, expressed or implied.
RECOMMENDED PULLEY ALIGNMENT VALUES
The standard limit for V-belt drive alignment is 0.5 degrees,
and 0.25 degrees for synchronous drives. Most major belt and
pulley manufacturers specify these values. Pulley alignment
can be set closer than this if the alignment procedure is
carefully followed. The following table converts degrees of
misalignment to mils/inch and mm/100 (of pulley diameter) of
misalignment between the projected planes of the pulley faces.
Angle Of
Misalignment
(degrees)
mm / 100mm
mils / inch
0.1 0.18 1.75
0.2 0.35 3.49
0.3 0.52 5.24
0.4 0.70 6.98
0.5 0.87 8.73
0.6 1.05 10.47
0.7 1.22 12.22
0.8 1.40 13.96
0.9 1.57 15.71
1.0 1.74 17.45
Bold
= within recommended limits for V-belt drives
Note that the values between 0.1 and 0.5 fall within
recommended misalignment limits for V-belt drives.
24
© 2011 Gates Corporation
EZ ALIGN is a registered trademark of Gates Corporation
GATES EZ ALIGN
®
TECHNICAL DATA
EZ ALIGN
®
LASER TRANSMITTER
Operating Distance:
6 Ft. or Better
Accuracy:
1/32” At 6 Ft.
Laser Type:
635nm Visible Laser Diode
Laser Power:
<1 mW, Class 2
Laser Line Length:
28” At 6 Ft.
Controls:
Laser ON/OFF Rocker Switch
Operating Time:
25 Hours Continuous At 72° F
Battery Type:
2 AAA Alkaline Batteries
Operating Temp:
15° To 110° F
Storage Temp:
-4° To 140° F
Mounting: Magnetic
Weight: 10.1
Oz.
Dimensions:
1.25” (W) X 1.25” (D) X 6.5” (H)
Housing:
Aluminum, Powder Coat Finish
EZ ALIGN
®
REFLECTOR
Reflector Size:
1” (W) X 1.4” (H)
Mounting: Magnetic
Weight: 6.2
Oz.
Dimensions:
1.25” (W) X .75” (D) X 6.5” (H)
Housing:
Aluminum, Powder Coat Finish
CARRYING CASE
Material:
Black, High Density Polyethylene
Dimensions:
10.25” (W) X 8” (D) X 3” (H)
Insert:
Die Cut Foam
Total Package Weight:
1.9 Lbs.
