REVISION 2019-2
GateMotors: +44 (0)1202 744958 • Technical support: +44 (0)1202 725489
www.gatemotors.co.uk • Sales and Accessories: +44 (0)1202 717191
• Cut off the power before starting the wiring.
• See the control panel instruction manual (separate documentation) and
refer to the Control Board section for guidance.
• A circuit breaker should be fitted close to the gate (
3 mm
wires) to
protect both the gate control panel and the property’s main fuse box.
A
6 A
automatic breaker or a
16 A
single phase breaker complete with
fuses shall be suitable.
• Make sure you have suitable tubing and conduits for the electrical
cables: feed the motors, control panel and accessories separately, in
order to prevent interferences that may result in bad operation.
• Fit the power cable keeping a curve as shown (pic Q) in order to avoid
water backflow inside the motor.
• The power supply lines – to the motors, to the control unit and to the
accessories, must be separated to avoid interferences which could
generate problems to the system.
• Any equipment (either of control or safety) connected to the control
unit must be tension free.
230V
A
Motor
3 x l,5 + T
B
Control panel
2 X l,5 + T
C
C
1
Photocells
Photocells
rx 4 x 0,50 mm
2
tx 2 x 0,50 mm
2
D
Key-switch
2 X 0,50 mm
2
E
Aerial
RG58
F
Radio receiver
2 X 0,50 mm
2
Wiring installation overview
INWARD FACING
(pic Q)
A
A
B
D
E
F
C
C
1
C
C
1
